SERVICING THE AUTOMOTIVE MANUFACTURING SECTOR FOR 24 YEARS

Water Saver/Tip Loss Monitor and Water Retract Actuator

Published May 1, 2017

All too often when changing welding electrodes the person removing the caps is immediately splashed with cooling water from the weld gun.

If this has happened to you, then you know this type of water is usually pretty nasty!  It could also be treated with expensive chemicals to inhibit corrosion and improve cooling so losing it on the floor is not the best solution.

Another scenario for water loss is in the case of a broken water hose, cracked adapters or electrode cap sticking to a part and being pulled off the weld gun when the robot retracts.

We can address both these situations with our line of Copperhead products, in this case our:

“Water Saver/Tip Loss Monitor and Water Retract Actuator”

For more information, check out our WaterSaver System.